In some cases, the buttons may get stuck. Verify if any keys are pressed in too deep.No lights or steady lights on your Shaw Direct remote control? Does it only work intermittently?
#DEPROGRAM URC REMOTE CODE#
Press and release each device key (SAT, TV, or AUX) that you wish to have programmed in the order you want them toggled when POWER is pressed.Press and hold SAT until the other buttons (TV and AUX) flash at least three times.
If held for less than three seconds, POWER button will only turn your receiver on or off. Note: POWER button must be held down for roughly three seconds in order to toggle all devices.
To have POWER button toggle your satellite receiver and other devices (such as your TV) on and off at the same time, follow the instructions below.
Press and hold the TV button until the others (AUX, SAT) flash at least 3 to 4 times.If not, repeat steps 2-3 using different codes given for your brand of the TV.Press the POWER button to turn it back on. If the TV turns off, you have successfully programmed your remote with the TV.Press in the 5-digit code that you noted down.On the top of your remote, press and hold the TV button until the others (AUX, SAT) flash at least 3 to 4 times.You can have your Shaw Direct remote control other devices, such as your TV, with the following methods:ĭownload this file and search for your TV brand.